Here it is, done 100%. Looks to be the first Square TA05 in Singapore though.
Fixed the short belts with their SDC-129F Belts, which are just 2 teeth longer.......=.=It does pull the space by alot, i now realise the diffrence the 2 teeth made.
Gay angle steering? lol.Ok, from this shot it looks like there is big ackerman angle, it doesn't, mainly because i took this at a weird angle, about 20 degrees from being perpendicular with the chassis.
Not sure what this picture can explain, I did not have this balance with my TB03 which is why i am pretty happy. It kept felling off the rear at any point, and with this Square TA05, it is a whole new different story. :)
One tiny bad thing, Space Constraint :(
This is a very weird wiring technique, which i spent hours to do this, but just one look through Japan's OTAR Conversions, I found this unique one to route the wires at the bottom instead of the top. I strongly did not want to go resolder my motor.
Looks clean eh? Look for the CA Stains.... lol.
40T pulley on Ball Diffrential, fixed the jerky effect by replacing it with a aluminium one....No not Tamiya, 3Racing. :S
Same thing, 3 Racing Spool on 30T pulley. Ok, you guys will ask, why there is both titanium and tamiya stock screws? Well, of 2 things, these aren't titanium but stainless steel(Hex Screws), and while building i ran outta Stainless steel screws, will need to make a trip back to industrail areas for them..... Got them REAL Cheap, About 40 Screws for $6, most of them on my TB03 which i am lazy to unscrew them from the bottom... :3
One last shot before i end off.Curently, this chassis has not had its first virgin run yet,mainly because i just finished this yesterday, i wished blogger updated its photo uploading interface bugs. The only thing you might find different when seeing it in the flesh would be the missing stabiliser set and aluminium bulkheads. I shoulda fixed up the rest before i upload these, but since i am that excited, i decided to show you guys first hand. My leg injury has gotten loads better, i am able to walk as i am before, which is why i can complete this, still i cannot rotate my ankles to beyond 180 degrees, it is still far too painful....
Big Thanks to Street Revo Trading at Woodlands for having stock of all these. I would not have made true my Ultimate dream, i stated in Mid-2009.
Just a small hint, my net updates will be very minor, such like my settings change, small pulley changes, occasional bling buys, and new shells and rims(Those in SPRCD should know what i mean :))
Alright, ending off here! See ya guys in a few weeks!
Total Cost of Spending: SGD$568.95
My pockets have been incinerated to smithereens now....
No comments:
Post a Comment